Key Features

• X-10 transmitter for two sequential X-10 addresses (ON/OFF).
• Built-in 16A appliance module.
• Two-way X-10 communications.
• Two wall switches can be connected with one MicroModule. One serves the internal appliance module and also gives the X-10 commands through the power line. The second wall switch is used to transmit a second X-10 address (ON/OFF).
• X-10 programmable with any X-10 controllers (A-P, 1-16).
• Responds to or ignores All-Lights-On and All-Units-Off commands.
• Built-in appliance module remembers its last known state between power failures or disconnections.

Typical Applications

• Installs behind conventional wall switches or into wall outlets because of the extremely small size of the module (minimum built-in depth 40mm, advised 50mm). The MicroModule is also suitable for installation into light fixtures, home appliances or for use in areas with limited space such as lowered ceilings.
• Universal compatibility. No limitation in choosing brand, colour or type of any wall switches and outlets.
• Can be used in combination with regular or momentary switches. These will be automatically recognised by the module.
• Install two-way switches without adding additional wires in between wall switches (the MicroModule transmits their status to other modules through the power line when manually switched).
• Execute macros and preferred scenarios with a conventional switch.

Control Wiring

• Blue: Neutral wire (0).
• Brown: Input 1, programmed base X-10 address plus control of the built-in appliance module. The built-in appliance module will switch from ON to OFF or vise versa when the brown wire is connected to the blue wire. At the same time, the programmed address will transmit the new status of the appliance module through the power line.
• Red: Input 2, second address. When the red wire is connected to the blue wire, the programmed address+1 will be transmitted. eg. When A2 is programmed as the base address, the address of A3 will be transmitted. If the status on the MicroModule was ON, an OFF command will be transmitted and the other way round for OFF.

Installation

To Install the AWM2 MicroModule, the following wiring are required at the installation point: Live, Neutral and Load.

• Take the wall switch out of the wall outlet.
• Disconnect all wires from the switch.
• Pull an additional Neutral wire if it is unavailable.
• Connect the Live, neutral and load wires to the terminals on the MicroModule.
• Connect the control wires to the existing wall switch(es) with the blue wire as the common.
• Position the MicroModule against the back wall of the wall outlet behind all the wires.
• The MicroModule is now ready for configuration.
• Refit the wall switches at its original position after the MicroModule has been programmed.

Documentation

• User's Guide (278K)

Technical Data

Supply voltage:      230V +10%/-15% 50Hz
Supply current:      =< 30mA capacitive
Making capacity:     2KW (incandescent lamp)
                     3A (motors)
                     16A (resistive loads)
Signal transmission: > 5Vpp in 5Ohm at 120KHz +- 1KHz
                     according to EN50065-1, EN50065-2-1,
                     EN50065-4-1
X-10 transmission:   1 pulse burst at zero and 180 degrees
Signal sensitivity:  25mVpp .. 6Vpp at 120KHz +- 4KHz
S to N ratio:        1.35:1
Connections:         Up to 2.5mm square
Ambient temperature: -10ºC to +40ºC (operation)
                     -20ºC to +70ºC (storage)
Approvals:           NEN-EN-IEC 60669-2-1 and NEN-EN-IEC-60669-2-2

Dimensions: Length 47, Width 18, Height 47 mm