Key Features
- Install at the circuit breaker/fuse box for X-10 control of branch lighting circuits or appliances rated up to 16A (ideal for aircon, heaters, etc).
- Works with X-10 controller and standard latched or momentary action wall switches, including "designer" wall switches.
The DIN rail switch is an X-10 controlled relay. Discretly installed at the distribution box, it switches hard-wired circuits with several switches (eg. hallway lighting). The internal relay can be tripped either by external latched or momentary action standard wall switches or by an X-10 controller. It responds to "standard" X-10 commands (All-Unit-Off, On and Off). When the relay is energised, the LED above the slide switch is illuminated.
Slide Switch
- 0: The connected load is switched off permanently and cannot be switched on by the wall switches or an X-10 controller.
- 1: The connected load is switched on permanently and cannot be switched off by the wall switches or an X-10 controller.
- AUTO: The connected load can be switched by the wall switches or an X-10 controller.
Terminal 1 is designed for toggle switches: the relay picks up when phase is present and releases when there is no voltage at the terminal.
Terminal 2 is designed for pulse contacts: each time phase is applied the relay switches from one state to the other.
Typical Applications
This unit can replace any pulse contact relay that is commonly used for multi-switched hall and entry lighting. In discrete locations, eg. kitchen lighting, you may prefer to install the AD10 in a small sub-junction box.
Technical Diagrams
Technical Data
Supply voltage: 230V +10%/-15% 50Hz
Supply current: =< 20mA capacitive
Making capacity: 2KW (incandescent lamp)
3A (motors)
16A (resistive loads)
EMC emission: According to EN50081-1
EMC immunity: According to EN50082-1
Electrical safety: According to EN60950 and EN60065
Signal sensitivity: 15mVpp min 50mVpp max at 120KHz
Input impedance: => 180Ohms (L-N) at 120KHz
Connections: Screw type terminals for phase, neutral,
switched phase, control 1 and 2
Ambient temperature: -10ºC to +40ºC (operation)
-20ºC to +70ºC (storage)
Dimensions: Length 88, Width 35, Height 65 mm
This product is CE approved for use in the EU. |
;)
